Has any one out here had any problems with Barnett cables specifiably the stainless braided cables for 2008 up "Hammer" i purchased a set from a un named dealer in factory sealed packaging the throttle cables looked great butt misfit@switch block by far! tlk to dealer deferred to Barnetts they then said they were sending me a new updated version of the throttle/pull back cables that they checked and quoted they checked them with my housing unit ( switch block ) and they fit great and i would be very happy with them well all that said they fit but still not rite the updated version was missing the inner liner surrounding the cable its self talked to a tec at Barnett and he ensured me not a problem and went as far as saying they only use them on there clutch cables even when the first set i received had the liner on cables, installed and my throttle cable is pulling very rough can feel the cable dragging/pulling on metal housing going to throttle grip! Any feed back may be helpful. I want to know if anyone has experienced any problems such as this. I have lost my bike for going on two weeks now and i am going to go through the process of trying to get a refund thew dealer and now also Barnett, thus going with OEM wtf I can't be the only one! read this exert from Barnett
Our control cables feature "long lay" (longitudinally wound) casing with 1x19, 7x19, or 7x7 stainless steel wire rope to eliminate flex and "include a Teflon, Nylon, or HDPE inner liner for smooth, reliable performance, and long life."